All types

Battery knowledge

ABSOLUTELY MAINTENANCE-FREE
LOW-MAINTENANCE
PLATE
POLARITY
SHIFT
SAFETY RESERVE
CONSUMER
SEALED BATTERY
MAINTENANCE FREE
PLATE
WATT
WATT-HOUR
IntAct Bike-Power AGM
IntAct Bike-Power Classic
IntAct Bike-Power GEL
IntAct Bike-Power HVT
Intact Bike-Power Lithium
PLATE PACKAGE
CAPACITY
CONNECTION POL
ELECTROLYSE
LEAK PROOF
BALANCING
BATTERY BOX
BATTERY CARE
BATTERY WATER
DOUBLE LID WITH LABYRINTH
ELEKTROLYTE
COLD START POWER
DEGASING
DISCHARGE VOLTAGE
FILL HEIGHT
GAS RECOMBINATION
FIBERGLASS FLEECE
HVT
HYDROMETER
intAct Bike-Power SLA
Charging correctly step by step
Tip: For full performance: Charge before first installation! 1. preparation Check that your charger matches the battery. Does the charger support the correct charging voltage? Does the charging current provided match the battery? What charging curve …
What does pole growth on the battery mean?
Whitish-grey deposits on the poles, so-called "pole growth", is caused by strong sulphation on the plates. Tip: Always ensure a good state of charge.
Checking the liquid level against sulphation
In a battery or accumulator, the chemical reaction between the active material of the grids and the acid generates current (electrons emitted) to supply the loads or stores current (electrons) provided by the charger or alternator. If the acid only partially …
What types of motorcycle batteries are there?
For motorcycles and four-wheeled small vehicles, there are classic flooded batteries in low-maintenance design (intAct Bike-Power Classic and Exide Bike Conventional) or maintenance-free (intAct Garden-Power), AGM batteries (intAct Bike-Power AGM, intAct …
A coherent equation: A lot out, a lot in.
Every battery loses power over time. If it is loaded normally and is always fully charged, the capacity is slowly reduced. If it is often overloaded and insufficiently charged, the capacity is reduced much more quickly, i.e. the battery ages much faster. Ideally, …
Always choose a battery that suits your individual requirements
Each battery technology has particular strengths, but also weaknesses. Depending on the requirements your battery has to meet in the respective application, or which properties you want, some battery technologies are more suitable or less suitable. It is important to weigh up the properties.
Chargers for rescue and safety vehicles
Emergency and rescue vehicles and other safety-related types of vehicles often sit around for months, but when it comes down to it, they need to be ready at a moment's notice to put out fires, rescue injured people or clear roads. Chargers like the Fronius …
AGM and SLA Motorcycle Batteries
In these valve regulated batteries, the acid is bound in fleece (Absorbent Glass Mat). They lose very little liquid and are absolutely maintenance-free when sealed at the factory. AGM batteries, which come with an acid pack, are maintenance free after …
What the battery does
In a nutshell, the battery generates electricity, which it delivers to the consumers. It is charged and is ready again. So far, so good. Meanwhile, a bit of chemistry happens inside the battery. Current flow In principle, current flows between a positive …
Filling a dry pre-charged battery
Dry pre-charged batteries must be filled with battery acid and charged before installation.

What is a motorcycle battery?

A battery that primarily starts the motorcycle. For this, the starter motor needs a lot of power for a short time. Important for this is the cold start power (CCA) that the battery provides, but also the characteristics. A battery with a high current reserve will start the motorcycle even partially charged, for example.
In addition, the motorcycle battery supplies the electrical consumers, since it is the only battery in the motorcycle. The more consumers are installed, especially retrofitted safety or entertainment features, the more capacity is needed so that the consumers are also supplied at idle or when the engine is off or the machine still starts after the consumers have been used.

 

Commissioning

value2

Maintenance and Care

value3