Abbildung Forster Thermo Control
Symbol: Eignung für Wohnmobile
Symbol: Eignung für Marine
Symbol: Eignung für E-boats (electric boat)
Symbol: Eignung für Solar applications
Symbol: Eignung für wind-power plants
Symbol: Eignung für Lifting platforms
Symbol: Eignung für Auto Hifi, Car Audio
Symbol 75 % weight saving
Symbol mounting angle 180º
Forster Thermo Control
Sealed lithium iron sulfate battery (LiFePO4) | Power Prismatic Cells (BPC) | absolutely maintenance-free

Forster Thermo ControlDurable performance in cold conditions


With charge absorption down to -30 °C and low self-discharge, ideally suited for non-heated areas such as an exterior battery compartment in a motor home or intermediate storage for solar or wind generators.
Our recommendation when cold plays an important role in the application.

Features

  • Particularly insensitive to cold

    With the special multi-layer heat system, this battery can be warmed up gently and efficiently. It can also be charged at -30 °C and discharged down to -20 °C.
    Your advantage: This battery can be operated well in non-heated, outdoor areas.

  • Very long service life

    Unlike lead-acid batteries, which sulfate at low charge, the LiFePO4 battery is resistant to deep discharge. It can withstand far more charge cycles to a significantly lower depth.
    Your advantage: You get a particularly long-lasting battery.

  • 100% usable capacity and expandable

    Unlike lead-acid batteries, the entire energy of this extremely compact LiFePO4 can be used. In addition, up to four batteries of the same type can be connected in parallel.
    Your advantage: Significantly increased capacity in a small space.

Characteristics

  • Safe lithium technology (LiFePO4).
  • Particularly good space utilization due to prismatic cells (Power Prismatic Cells / BPC).
  • Forster Power Battery Management System (BMS) for safe operation and long service life.
  • Supports almost all boosters, shore chargers and solar charge controllers thanks to Multi Charge Mode (MCM).
  • Extended cold resistance for use down to -20° C
  • Advanced cold resistance for charging down to -30°C.
  • Efficient heating for charging with Multi-Layer-Heat System (MLS) for gentle and power-saving heating from the inside to the outside.
  • High heat tolerance for safe supply even at ambient temperatures up to 60°C.
  • Weight and space savings of up to 75% compared to a conventional battery of the same capacity.
  • Low self-discharge. Loses only 2 to 3 % charge per month.
  • Flexible installation position. Can be installed upright, lying down, upside down and in any other position.
  • Resistant to low charge. No sulfation. High performance throughout the discharge period.
  • Extremely long life expectancy with full capacity utilization. Up to 4,000 cycles at 80% depth of discharge (= 80% DOD).
  • Capacity expandable by parallel connection of up to 4 batteries of the same type.
  • Monitoring via integrated Bluetooth Free Smart Connect app for Android and iOS.
  • Fully charged extremely quickly. bsorbs extremely high charging currents in a very short time (charging time depends on capacity and charger).
  • Ready for installation and immediate use.
  • Absolutely maintenance-free.
75 % weight saving
mounting angle 180º

All types

Forster Thermo Control

Battery Volt Capacity CCA Length mm Width mm Height mm Pos. of terminal Terminal
F12-100FBSHi12,8100Ah (c20) 1280Wh35317519001more
product image Supply Battery Forster Thermo Control F12-100FBSH

F12-100FBSH

Japan-Code:{jpn}

F12-100FBSH

Position of Terminal:0
Schema Schaltung 0
Volt:12,8
Terminal:1
Schema Endpol 1Schema Endpol 1
Capacity:100Ah (c20) 1280Wh
Base plate:B13
Schema Bodenleiste B13Schema Bodenleiste B13
Cold Cranking Ampere:
Size:353 x 175 x 190 mm
Schema Batteriekasten L05

Kasten: L05
Where can I buy this battery?

Dealer online shop

Buy online

Locally

Dealer locator
Download datasheet
F12-150FBSHi12,8150Ah (c20) 1920Wh35317519001more
product image Supply Battery Forster Thermo Control F12-150FBSH

F12-150FBSH

Japan-Code:{jpn}

F12-150FBSH

Position of Terminal:0
Schema Schaltung 0
Volt:12,8
Terminal:1
Schema Endpol 1Schema Endpol 1
Capacity:150Ah (c20) 1920Wh
Base plate:B13
Schema Bodenleiste B13Schema Bodenleiste B13
Cold Cranking Ampere:
Size:353 x 175 x 190 mm
Schema Batteriekasten L05

Kasten: L05
Where can I buy this battery?

Dealer online shop

Buy online

Locally

Dealer locator
Download datasheet
F12-200FBSHi12,8200Ah (c20) 2560Wh4851702451F-M8more
product image Supply Battery Forster Thermo Control F12-200FBSH

F12-200FBSH

Japan-Code:{jpn}

F12-200FBSH

Position of Terminal:1
Schema Schaltung 1
Volt:12,8
Terminal:F-M8
Schema Endpol F-M8
Capacity:200Ah (c20) 2560Wh
Base plate:none
Cold Cranking Ampere:
Size:485 x 170 x 245 mm
Where can I buy this battery?

Dealer online shop

Buy online

Locally

Dealer locator
Download datasheet
F12-300FBSHi12,8300Ah (c20) 3840Wh5202682204F-M8more
product image Supply Battery Forster Thermo Control F12-300FBSH

F12-300FBSH

Japan-Code:{jpn}

F12-300FBSH

Position of Terminal:4
Schema Schaltung 4
Volt:12,8
Terminal:F-M8
Schema Endpol F-M8
Capacity:300Ah (c20) 3840Wh
Base plate:none
Cold Cranking Ampere:
Size:520 x 268 x 220 mm
Where can I buy this battery?

Dealer online shop

Buy online

Locally

Dealer locator
Download datasheet

Battery knowledge

What do deposits on the battery plugs mean?
Black deposits on the plugs indicate a battery that has worn out prematurely due to continuous excessive load. Tip: Always ensure a good balance between current drain and charging. Information on capacity calculations and charging behaviour can be found …
When liquid is lost
Fluid evaporates in batteries during the chemical reaction to generate electricity, more so in a wet battery than in an AGM or GEL battery where the acid is fixed in non-woven or as GEL respectively. Unlike these sealed batteries, the vapor in the sealed …
Checking the liquid level against sulphation
In a battery or accumulator, the chemical reaction between the active material of the grids and the acid generates current (electrons emitted) to supply the loads or stores current (electrons) provided by the charger or alternator. If the acid only partially …
AGM or GEL drive batteries
Drive batteries in AGM or GEL technology are sealed, absolutely maintenance-free, leak-proof batteries in a closed design with a fixed electrolyte (in fleece or gel). Both are suitable for medium to heavy cyclic use, for example in cleaning machines, …
Why should you charge wet batteries open?
Gases are produced during charging. As they rise, they mix the battery acid. It is better for the battery if it is open during this process. Important: This only applies to initial charging and to all batteries that can be opened. Never open a battery by force!
Always choose a battery that suits your individual requirements
Each battery technology has particular strengths, but also weaknesses. Depending on the requirements your battery has to meet in the respective application, or which properties you want, some battery technologies are more suitable or less suitable. It is important to weigh up the properties.
Our absolutely maintenance-free motorcycle batteries
intAct Bike-Power AGM, intAct Bike-Power SLA, intAct Bike-Power GEL, intAct Bike-Power HVT and intAct Bike-Power GEL HVT-HD are valve regulated lead-acid batteries or VRLA batteries (VRLA=Valve Regulated Lead-Acid). VRLA batteries produce much less gas …
Supply batteries with armoured plates
Wet deep-cycle batteries in armoured plate or tubular plate technology are designed for the most severe loads. Due to their structure, the tubular plates used provide a larger surface area compared to grid plates and thus more active mass for the chemical …
The order of disconnection and connection
The negative terminal is connected to the body, hence the name grounding. If you accidentally touch the positive terminal and the body at the same time when the negative terminal is connected, e.g. with a metallic tool, a short circuit could occur that …
What waterproof brings
Ideally, batteries should be kept dry. Even slight moisture can promote leakage currents. If you've noticed condensation on your battery frequently in the past, such as with temperature fluctuations, or water can get to your battery, it's worth considering …

What is a Supply Battery?

Supply batteries must provide power for as long as possible for consumers that are not connected to the regular power grid or the starter battery. Either in mobile applications, e.g. camping or in island installations such as mountain huts, or in safety applications when the normal power grid fails or to compensate for so-called mains wipers. Depending on the application, they are charged with a charger from the mains or via smaller photovoltaic or wind power systems.

So not only do they have to supply power for a long time and then take it up again well, but they also have to cope well with changing current levels and voltages.

Supply batteries are cyclic batteries, i.e. they are designed to continuously deliver current up to a maximum depth of discharge of 80% when supplying electrical consumers and then to be fully recharged again. In contrast, a starter battery delivers a short, strong current surge for starting the engine and is recharged by the alternator while driving.

Für welchen Einsatz ist die Forster Thermo Control geeignet?

Symbol WohnmobileWohnmobile
Wohnmobile, Caravan, Motorcaravan, Motorhome, Campingbus, Reisemobil, Alkoven, Campingfahrzeuge
Symbol MarineMarine
Boats, ships, yachts
Symbol E-boats (electric boat)E-boats (electric boat)
electric boats or electric ships.
Symbol Solar applicationsSolar applications
Small to medium-sized solar systems/solar applications e.g. in camping, stand-alone operation etc.
Symbol wind-power plantswind-power plants
As a power storage for small to medium-sized wind power plants or wind turbines.
Symbol Lifting platformsLifting platforms
For electrically operated lifting platforms, scissor lifts, telescopic lifts, trailer lifts, mast lifts, vertical life
Symbol Auto Hifi, Car AudioAuto Hifi, Car Audio