The order of disconnection and connection
The negative terminal is connected to the body, hence the name grounding. If you accidentally touch the positive terminal and the body at the same time when the negative terminal is connected, e.g. with a metallic tool, a short circuit could occur that …
Charging correctly step by step
Tip: For full performance: Charge before first installation!
1. preparation
Check that your charger matches the battery.
Does the charger support the correct charging voltage?
Does the charging current provided match the battery?
What charging curve …
Ideally, batteries should be kept dry. Even slight moisture can promote leakage currents.
If you've noticed condensation on your battery frequently in the past, such as with temperature fluctuations, or water can get to your battery, it's worth considering …
First the format, then the capacity
A battery must of course fit in your vehicle, machine or device. Check the dimensions of your old battery or the available space where you want to install the battery.
Check that the terminals are easily accessible, that you can reach them easily with …
What is sulfation and what can you do about it?
Sulphation or sulphation is an undesirable ageing process in batteries where too much lead sulphate forms on the lead plates, which cannot be removed even with prolonged charging. The battery's capacity drops significantly, or it fails altogether. Sulfation …
A coherent equation: A lot out, a lot in.
Every battery loses power over time.
If it is loaded normally and is always fully charged, the capacity is slowly reduced.
If it is often overloaded and insufficiently charged, the capacity is reduced much more quickly, i.e. the battery ages much faster.
Ideally, …
With each charge/discharge process (cycle), active material is inevitably lost and the battery's performance declines. Once it has fallen to the point where it can no longer fulfil its purpose - e.g. start the vehicle, supply the consumers or drive the …
Installing the starter battery or motorcycle battery
First connect the positive cable (usually red) to the positive terminal of the battery.
Then connect the negative cable (usually black) to the negative terminal of the battery.
If you install a start-stop battery, you must then register the battery in the vehicle system.
Chargers for traction batteries
As with supply batteries, traction batteries are used in cyclic applications, i.e. the batteries are used until they are quite empty and are charged during idle times. Here, the charger is part of an effective drive application. The efficiency of the …
Drive batteries with armoured plates
Wet deep-cycle batteries in armoured plate or tubular plate technology are designed for the heaviest loads. Several tubes, in which the active mass is quasi "armoured", are joined together to form plates. This design makes them extremely resilient …